What is the best way to connect the antenna’s oval mast mount to a round mast? Two evenings and quite a few cups of coffee later, I had the solution.

By default, the Buddihex beam is mounted on a Mastwerks mast. But since I don’t own that mast and like to optimize the things I have and use them for more than one purpose, I needed a different way to mount the antenna.
For various operations I use my air-damped, 7-metre telescopic light mast, which can carry a head load of 25(!) kilograms. Unlike the Mastwerks mast, however, it is round rather than oval.
The challenge: determining the dimensions of the mast mount on the Buddihex beam.

Armed with a digital caliper and a few radius gauges, I set about determining the approximate dimensions. I then transferred the values into a drawing program and laser-cut a first prototype from an 8 mm wooden board. I fixed the freshly cut shape with a screw and pushed it into the beam’s mast mount to check how accurate my measurements really were.

Unfortunately, the first two prototypes didn’t fit at all – the radii clearly needed rework. But with every correction I got a little closer to the goal. The third shape was already pretty good, and with the fourth everything finally matched! Perfect fit, exact dimensions – I had found the right shape!
In the next step I transferred the dimensions into a CAD program and redrew the exact shape there. Then I added the round socket for my light mast – the missing piece of the puzzle.

Once the design was finished, I sent the model to my 3D printer. Now came the exciting moment: layer by layer, the new part took shape before my eyes – precise, tangible and exactly as I had imagined it.
It was especially important to me that the new beam mount fits into the bracket of my light mast. Under no circumstances did I want to mount the antenna off-centre – that is, to the side of the vertical axis. Only this way could I make sure that the head load stays perfectly centred and the mast keeps its stability.
Conclusion
The project was a complete success. From the first rough measurements to the final, perfectly fitting mount, every single step was worth it. The mix of careful planning, technical understanding and a bit of patience led to a result that not only works flawlessly but is exactly what I had in mind. It’s a great feeling when your own idea takes shape and fits so perfectly in the end.



